Stuck on Powering Up....

2 posts / 0 new
Last post
Stuck on Powering Up....

My series 2 140060 tivo was having some issues with locking up.  After doing some research all signs pointed to HDD failure so I decided to try and clone the drive using WinMFS to no avial.  I have recently decided to abandon that and just get the tivo up and running again by using an instantcake image on a fresh drive Hitachi 160GB.  I used an old Gateway 300s to make the transfer as the Linux program will only work with 2 IDE ports and the cake baked fine according to the program.  I pop the newly baked drive in and it just sits at the Welcome Powering Up....  screen.  I have reseated all cables and tried jumpers set to master, slave and cable select.  I am at a loss as to what else I can do with this.  Any suggestions?

Well...no replys but 16 views

Well...no replys but 16 views. Either this is a problem too big for me to handle myself for these forums are dead. Any suggestions for a different place to post my question?